Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, we can map the VLAN statically in the scenario you described. This is also known as static encapsulation and are supported for service graph connector that has a service device cluster with physical services.
To know more about the configurat...
Hello,
I believe you can configure the Interface in 'int_routed_host_11_1' policy making the interface L3 and then configure 'Subinterface' to further configure SVI if required.
'Freeform Config' is a great way to customize your trunk interface to...
Hello,
I would suggest verifying the below -
1) Configure an out-of-band contract allowing SNMP traffic. SNMP traffic typically uses UDP port 161 for SNMP requests.
2) Configure the APIC out-of-band IP addresses in the 'mgmt' tenant. Although the out...
Hello,
This seems to be a valid configuration from the ACI perspective (a device connected with vPC to a L3Out and running a routing protocol with ACI) and if VSS MEC matches the L2\3 configurations similar to ACI, this must be feasible.
P.S. I am ...
Hello,
The recommended approach of connecting on-Premises ACI with Azure ExpressRoute is described in the "Intersight Connectivity" section in this documentation - Cisco Cloud Application Policy Infrastructure Controller - Cisco Cloud ACI Hybrid Mu...
