Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an ASA 5510 at Site A with a L2L tunnel to another site, Site B. Single subnet at each site. In a few weeks we will be adding a secondInternet connection to Site B, so both connections will be active. But we want traffic to go over the new co...
I have four 3120's in an HP blade system that are currently configured as 4 standalones. I want to stack them. is it as easy as configuring the first one as switch 1 and then connecting the stackwise cables? Will I need to reboot anything?
I have an ASA 5510 that has Remote Access VPN and a Lan-To-Lan set up and working great. Local nets and users on the RA net can access networks across the Lan-To-Lan no issues. I added a second Lan-To-Lan to another site and only the local network ca...
Hi Federico,Thanks for the reply! So on site A crypto map I can specify the primary address to use to get to Site B and if that's not reachable it will try a secondary address? What is the crypto map command to do that?Thanks!!
Thanks James. The negotiated SA shows the correct subnets configured but shows errors related to the RA network SA so it seems the problem is on the Juniper side. The admin on the other end says the network/mask is correct but unfortunately I don't h...
It does. It is configured for the local net and the RA net to communicate with teh network on the remote end. Another L2L tunnel on the same ASA works fine, but this one to the Juniper does not. Any known issues with Tunnels to Juniper FW's?
