Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have laptop connected behind IP phone, and problem is, when laptop disconnects from LAN, port still remains authenticated. On PCs I use dot1x and on IP phones MAB, so host-mod is configured to multi-domain. Is there any solution how to prevent ...
Hi, I have configured automatitic archivation of running config via archive command to TFTP server. I have done the same configuration on 8 switches, but 4 of them doesnt archive config properly, they archive "blank" cfg 1kB of size. If I use write c...
Hi, I there any way how to restrict or shape maximum bandwith for specific vlan? I would like to set the maximum speed of 2Mbps. This vlan is used for WiFi connection,for internet access only. Thx
Hi there,
today I found theese log messages but I have no idea what they are about. No changes has been recently made.
1355235: Nov 20 11:23:57.793: %C4K_HWFLOWMAN-3-NFEINTERRUPTSTATUS: (Suppressed 6765 times)module: fl InterruptStatus: 0x81355236:...
Hi there,
is there any way, how to restrict traffic within VLAN? In my case I have vlan 40 (its range is from 10.1.40.0-10.1.43.255)
I have created ACL like this and applied to vlan interface with inbound direction.
Extended IP access list tlac ...
PS is disabled, correct me if Im wrong additional info about HW:Cisco IOS Software, C2960S Software (C2960S-UNIVERSALK9-M), Version 12.2(55)SE3, RELEASE SOFTWARE (fc1)Technical Support: http://www.cisco.com/techsupportCopyright (c) 1986-2011 by Cisco...
