Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I'm hoping someone here can help, I'll start off by saying that my Cisco knowledge is minimal, though I'd say my general networking knowledge is good.
My employer currently uses a Nomadix gateway router to manage their incoming connection. The...
Hi All,I had the same problem so I knocked up a compatible bracket in Tinkercad. If you have access to a 3D printer you can now print your own solution: https://www.thingiverse.com/thing:6393289
Thanks, I didn't get much time today to check things but it looks like the problem is with NAT.
I spoke to one of our head office network engineers and he said it definitely sounds like it, I've sent the config to him and he's going to check it o...
Hi, here's the IP info from my provider:
IP Pool: 14.142.2.144/29
Network IP: 14.142.2.144
Gateway: 14.142.2.145
The IP allocated for this router: 14.142.2.147
Subnet: 255.255.255.248
Hi, here is the output from "sh ip route":
Gateway of last res...
Many thanks for the reply!
I follow what you're saying, I understand about public/private ranges and I've turned NAT on on both interfaces.
Where/how can I add the gateway address so that traffic is routed correctly? I was leaning toward that bein...
