Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I uninstalled VPN client and now I can't reinstall it. I have tried different versions with no luck.If I try to install version 4.6 from MSI packet I get error: another version of this product has been found. It will be uninstalled first and then...
I have a cisco 877 router (Cisco IOS Software, C870 Software (C870-ADVIPSERVICESK9-M), Version 12.4(9)T, RELEASE SOFTWARE (fc1))On the router I have servers directly connected to it and I have a sonicwall firewall also connected to it. Behind the son...
HiI need to do site to site connection with two pix 506e firewalls. On the other side is lan and on the other side is customers server. I was able to make a VPN tunnel so that all traffic went trough the vpn tunnel to the server. But after this I cou...
Hihow can I make ASA to let everything go trough it? everything should be allowed from outside to inside and vice versa. Should I make a static nat for the whole public network or just with access lists?
Hi,I have a situtation where I have web servers with public IP addressess that I'm going to migrate behind one address, but behind different ports.Can I do port forwarding with ASA so that when connecting from network 0.0.0.0 to port 80 on ip x.x.x.x...
If I contact the provider who controls the router I talk to myself... Well I'll have to try with just extended access-lists with the established parameter. I had problems with DNS when I tried with extended access-lists but I didn't use any establis...
Access-lists are because the servers are directly on the Cisco router. Thats our DMZ solution. Not that good, I know but can this work the way I want?What I want is to allow everything to 11.0.0.1 because this is the address to the sonicwall and I al...
I did configuration accrording to: http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a0080094761.shtmlNow I can connect to Internet from both lans and there is active ipsec connection between firewalls BUT I can...
Yes. You could simply create separate tunnel-groups for each customer, and the traffic defined within that vpn would be to specific servers ip addresses.how do I specify the addressess the client can connect to?
