Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,consider following small frame relay network: [r1] | Se0 | / \DLCI 102 / \ DLCI 103 [r2] [r3]Configuration of frame relay is done entierly on main serial interface on all routers (i.e. sub-interfaces a...
'ip route 0.0.0.0 0.0.0.0' is like applying unconditional (no 'match') PBR to all interfaces, but such use of PBR is rare and hardly justified.If a packet didn't match any of the blocks of your PBR route-map then it falls back to normal routing looku...
We're running many NPE-G2 since the moment they became available. Tested many images and came to conclusion that 12.4XD train is the most usable out of all that available for this platform. If you're not running LNS/LAC, you can take 12.4(4)XD7. If y...
if your routing table doesn't have too many flapping routes, you could try 'debug ip routing' and see what causes route refresh. Best place to watch this is first router(s) where path from those redistributed towards area with problem and without pro...
7200 implements QoS in software, whereas on GSR it's implemented in HW. Some differences are due to implementation. I haven't had need for several WRED profiles per queue, but for example number of queues is limited in GSR and scheduler is hardware M...
