Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am not clear on the exact meaning of "match as-path 3" in the following route statement, how does it translate?route-map SET_LOC_PREF permit 10match as-path 3
Please take a look at this and explain why the variance command is not adding the serial connection path to the routing table along with the fast ethernet interface. A variance of 10 should be all that is needed, and I have tried 100 just to be safe,...
Can someone please refresh me as to what the command is to change the Native VLAN for the entire switch? (IE: not just on the trunk, I mean the default native for the entire switch). Thanks
When setting up a frame relay topology, and setting up the serial interfaces on the spoke routers (hub and spoke topology) is it required to specify "point-to-point" or "multipoint" on the interfaces? The only way to specify these settings are to cre...
I think my config is correct, but I can't even ping the local IP address on each spoke router, on a hub and spoke network. I have a 2610 as the switch, and all routes are active:RA#sh frame-relay routeInput Intf Input Dlci Output Intf Output Dlci Sta...
This is probably related to why, when I went the other end of the network to RD, I was able to load balance there back to the 170.170.0.0 network -- I'll check the FD and reported metrics there. Thanks all for the great posts and very helpful explana...
Thanks for the info! It must have been something I did in the config, I will try it again using the physical interfaces --- it's working fine now using the subinterfaces so maybe I just needed to practice it once! I am just in a lab getting the feel ...
