Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I know that this will sound odd, but how do I turn off all IPv6 from running in a C9300 running IOS-XE 17.9.5
I've found many articles and STIG's that accomplish this via complicated ACL's but I would like to think there would be an easier way
3 c9300-48H stack was updated from 17.06.04 to 17.06.05 and now 90% of the POE phones are having this error flop on and off.
Did not see this issue in 17.06.04
ILPOWER-5-PD_ENTRY_REMOVAL
ILPOWER-5-IEEE_DISCONNECT
ILPOWER-3-CONTROLLER_PORT_ERR
MHM,
Thanks, but it's not an option on my interfaces under the 17.9.5 version. Looks like I'll have to implement the larger grouping of ipv6 access-list method
- Joe
Finally got the devices back under maintenance and when I updated this time, I chose to move to 17.09.03 which worked just fine, and all of the devices powered on without issue.
Funny thing on the way to support . . . found that my unit had been dropped out of service. So, I'm in the process of getting it under support. Once that completes then I'll input the ticket and share the SR# Sorry for the delay
- Joe Duffy...
It's the whole stack.
Attempted to use the 'inline power' on the interface command with no success
Funny thing is when I reverted back to 17.06.04 the entire stack worked with the 140 Cisco VOIP POE phones across the three switches.
So I'll be putt...
