Hi, I need help with the MSTP configuration relating to instance etc, by which i can have this topology up and running and also pass traffic around.SW7 is a L2 switch is trunk linked to SW5 and SW6. These trunk links carry Vlans 200,25,2100. SW5...
Hello Tutor, I have 2 Vlans, 10 and 20 on my 3560. Now I map instance 1 to vlan 10 and instance 2 to vlan 20.Ge0/1 is a vlan 10 access port and Ge0/2 is a vlan 20 access port. The rest of the configurations are left at defaults. Now I con...
Hello Belal, The Guard root is usually configured on a port connected to another switch which could have a probability of sending lower priority BPDUs which could cause your manually configured root switch to become a designated bri...
Mark, Without pressing any MODE button on the switch, power the switch back up and then immediately press Cntrl+break multiple times. Did you try this method as well? This should surely work.-/ Kiran
Hi Francisco, I am not too sure if we would call this a destination NAT, cause, as per the NAT command you are still translating the source address to 192.168.60.1 and 192.168.70.1 based on the matching ACL. The destination addre...
Again.... any takes? I really could use some clue or idea for the same. I tried avoiding using the IST and separated my Vlan into Insatance 1 and 2. But still i see some disruption in connectivity.-/ Kiran
Or, we could just press Ctrl+break ( could have to be done multipel times) as soon as the switch boots up to get into the rommon prompt and from there on it is an easy take.-/ Kiran