the two out stations are connected to router 1841 on s0/0 and s0/1 on same WIC card (smart serial) and one of the station is connected on normal s0 and local stn on e0. station s0/0 is connected with out stn on 2mbps through modem and stn s0/1 is con...
hi ,When i am switching on the router i am getting the output :" system bootstrap, version 11.0(10c), softwarecopyright (C) 18601996 by cisco systemsBad memory - wrote zero , read 0x00000900 at location 0x00000010 "what would be the problem ...
hi ,A LAN is connected to VLAN configured in sw3560 which usually gives error of loopback and shutting down the port.when we go through CNA , a notification gives a msg" check configuration of the switch , also make sure devices connected to the sw a...
hi,I am phasing a problem in RAS cisco 2500, when its boot up , it stops at "Rourter(boot)>" prompt whereas in others it stops at "Router>" what would be the reason and whether it could be resolved or not ,if yes then how..tks...mitra..
I am using sw 3560, where im getting notification on log file i.e"NATIVE_VLAN_MISMATCH: NATIVE VLAN MISMATCH DISCOVERED ON FASTETHERNET0/10 (6), WITH OUTSTATION FASTETHERNET0/15 (4)."I want to know why it is coming and what will be the consequences i...
tks for nice guidance..I tried your suggestions but i found that while running sh flash we get:1. 5710180 c2500-i-l.120-7 [invalid-checksum]router(boot)#I am unable to copy ios form ftp because there is no option of ftp while coping form ft...
hi . tks for good suggestion..Is there may be this reason also that isif a loop back adapter is configured in some of the pc inside the LAN.this is may become the reason for loopback error.tks...
Thanks for nice suggestion.I have checked the log and found :"duplex mismatch discovered on Fastethernet0/5 (not full duplex), with destination _router fastethernet0 (full duplex)."I have changed the speed and duplex both to auto, but in real time ...
sorry, i would have given u full detail..a physical flash memory is avl in the router, but the ios may be courrpted or erased from the router because due to sudden power break down router sttoped working.-is it possible to put ios on physical memory ...