Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am setting up Unity 4.0(4) which will take over the Unity Express 2.1.1 already setup. I would like to move the voice mail already stored on Unity Express to the new server. Can this be done? And if yes how?
on my two DMZ i am setting up. the line is up but the protocol is down. I can not figure out how to get it up. This is a new setup. one is staight to a server and the other to 6509 switch. Any help would be very nice. My head is going to go boom.Jaso...
Try to find a new firmware load for my 7960ip phones. My CCM is running 3.1.2C. I tried using POS303000.bin and it did not work. anything else out there beside this one and default P00303010102ThanksJason
I am running 3.1.2c and have been for several months.I only have 7960 phones. Now this started yesterday morning. When someone calls to automated system such as cisco help desk and the automated system askes you to push 1,2 or 3 and when hit a number...
We are try to hook up Valcom to my CCM. The Valcom supplies its own dial town. So they looking for a trunk. Is there a way to set that up on a FXS Modual? OR how else would i set that up?ThanksJason
No chages where made. I have three PSTN Digital lines going into a 6509 8 port t1. I have tried a new load for the gateway. and that did not help. i was running D001Q022 and now i tried D00403010032. I have reset the gateway frome both sides also. my...
What i was looking for was password protected sign in to the Meet Me. If there was such a thing. Or what other software would be able to do the same thing?
