About jwaldrop4frnt

jwaldrop4frnt · 03-18-2010

I have installed Windows 2008 R2 on a blade in a boot from SAN configuration. I loaded the Cisco Palo FCOE drivers during the install and it went through without a hitch.After the install the reboots are painfully slow, like 15 minutes. After boot up...

jwaldrop4frnt · 03-17-2010

Anyone know if there is a Windows 2003 VIC driver? I fond the Windows 2008 x64 one on the UCS Downloads page.

jwaldrop4frnt · 03-12-2010

Anyone know how to present more than 2 vNICs with the new Palo VIC? Tried adding eth2 and eth3 but they show up as down inside ESX. Also created a dynamic vNIC policy with 6 vNICs but then no vmnics show up in ESX.

jwaldrop4frnt · 03-08-2010

Does anyone know how to reset a UCS system to factory defaults? We have a UCS lab at the office and we need to be able to reset everything back to factory defaults so that multiple people can learn how to build a UCS system from the ground up.

jwaldrop4frnt · 03-23-2010

Manish, thank you. I have looked at that link several times and never noticed the supported OS section. I also found the very helpful PDF last night.http://www.cisco.com/en/US/docs/unified_computing/ucs/interoperability/matrix/hw_sw_interop_matrix_se...

jwaldrop4frnt · 03-19-2010

I used Clariion Open with failover mode set to 1.

jwaldrop4frnt · 03-19-2010

I checked all of that already, also when I did the initial install I only presented one path to the LUN. The slow boot started happening immediately after the install when only one path was presented to the blade.I then presented all four paths and i...

jwaldrop4frnt · 03-19-2010

Steve, it is a Clariion CX4-120. I have disabled the quiet boot and I can see the Palo FC HBA driver load and it displayes the boot LUN, after that it goes to a black screen and sits there for around 15 minutes and then boots into Windows.I am on fir...

jwaldrop4frnt · 03-13-2010

thank you, that was a lot easier than what I was trying to make it. I see 4 vmincs nowvmnic0 0000:08:00.00 enic Up 10000Mbps Full 00:25:b5:0c:95:af 1500 Cisco Systems Inc VIC Ethernet NICvmnic1 0000:09:00.00 enic Up 10000Mbps ...

Member Since	‎02-07-2007 06:34 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	12

User Statistics

User Activity

Windows 2008 R2 Very Slow to Boot from SAN

Windows 2003 Palo (VIC) Drivers

Palo configuration guide

Reset UCS to Factory Defaults

Re: Windows 2003 Palo (VIC) Drivers

Re: Windows 2008 R2 Very Slow to Boot from SAN

Re: Windows 2008 R2 Very Slow to Boot from SAN

Re: Windows 2008 R2 Very Slow to Boot from SAN

Re: Palo configuration guide