Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I'm new to ASA but i am learning as i go... I recently set up clientless VPN on my 5512x cisco ASA.I added a few bookmarks (a combo of webpages and web application pages that require you to log in). there are no issues when clicking on the boo...
I have a couple of ASA 5512-x (running same ios software v9.8(3)), one of them has the security plus license required to enable HA pair (failover active/standby).I was of the impression that you only needed one security plus license to enable HA.But ...
Got a flapping link between 2 of my MLSwitch (both are Cisco 6800-XL).int Te7/3 on MLS_1 to int Te7/1 on MLS_2the fiber connector on MLS_1 is SC, while the fiber connector on MLS_2 is LC I have changed the fiber cable (Single-mode LC-to-SC) and I hav...
I moved both interfaces to another slot/linecard and that fixed the issue. no more flapping.
so the issue is with the linecards that the interfaces were on, and I find it weird because they are other "up" ports/interfaces on these linecards, so why w...
i have swapped ports on both switches (on the same line card)
i have swapped cables also still flapping
link is connected directly between the switches (no patch, no tap), both switches in the same rack (one above the other)
i have replaced both tran...
made a mistake in the post.both actually use 10Gbase-LR transceivers, but just diff connector types, LC on one end and SC on the other.connected by single mode fiber cable
