Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I would like to configure Port forwarding on ASA 5512 v9.2, but no chance to get it up and running. My topology is the following
PC(Running License Server in port 27000 IP. 192.168.X.X) -- SW (192.168.X.X) -- Inside--FW5512 --Outside -- Inte...
Hello,
I have a problem joining 10 CISCO AP's 1041N to a WLC 2500 Series.
I have the following network architecture,
A Windows Server 2012 R2 (DC, DHCP and DNS Server) connected to CISCO 2960-X Series (This switch is connected to 2 other switches, s...
Hello,
I have an IBM Server with 4 NIC's and 3 CISCO 2960-X 48 Port PoE Switches, my question is about the best architecture I can use with the hardware I have in order to get a good networking performance, the 3 switches are separated, each one in ...
Maybe this could help,
ap#show configUsing 1410 out of 32768 bytes!! Last configuration change at 01:51:07 +0100 Mon Mar 1 1993! NVRAM config last updated at 16:13:39 +0100 Tue Mar 8 2016! NVRAM config last updated at 16:13:39 +0100 Tue Mar 8 2016ver...
Thanks for the answer, I have enough licenses for the WLC (10 in total)
I tried the command and I got the following message
ap#capwap ap controller ip address 192.168.1.7 ^% Invalid input detected at '^' marker.
ap#
Thanks Leo for your answer,
The idea is to make the 3 switches like clients to the server (Internal, DC, DHCP/DNS Server) with the 4 NIC's, so I want the 3 switches to act like a bridge to clients (CISCO WLC, CISCO AP's, Smartphones, Laptops, Printer...
