Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,on cisco router we configured remote access vpn but after configuring ip cef command split tunneling stopped working So please anybody have any solution interface Loopback 0 ip address 10.1.1.1 255.255.255.0 ip nat insideip access-list extend...
Hi,Please guide me what are default ports are open on asa 5520 from outside interface (Zero level Security ) to inside interface (Security level 100)Thanking youWith RegardsNil Jos
Jennifer,Earlier i was with same impression as you have but yesterday I found below ports open on my asa by default without adding any configuration line from outside to inside i think some additional ports are also open by default if anybody have p...
Hi,Is IPSec Stateful failover works on your bgp configuration , bcoz on my site i configured IPSEC stateful failover but it not works http://www.gotolightspeed.com/en/US/prod/collateral/iosswrel/ps6537/ps6586/ps6635/white_paper_c11_472859.htmlI done...
