About RKB04071984_2

RKB04071984_2 · 09-15-2010

Hello!I'd like to know if Cisco SFE 2000 supported IPv6.Because the datasheet doesn't have any information about it. Link reference:http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps9967/ps9980/data_sheet_c78-502066.htmlHowever the same pr...

RKB04071984_2 · 09-19-2012

Hello,Did you check the switches? Aren't there any interface error? Sometimes the problem can be physical. A cable or a interface issue. If you have checked it before I would say to look for errors in the server. In a case of the problem in the swit...

RKB04071984_2 · 09-19-2012

Hello,I don't know what IOS version you have. BTW the latest IOS 15.0(2)SE support limit bandwidth on an egress port and you can configure it in all interfaces.Check the link below for more details:http://www.cisco.com/en/US/docs/switches/lan/cataly...

RKB04071984_2 · 09-17-2012

Hello,I would say to have the configuration file is enough. Otherwise you should keep your topology documentation up to date in case of a disaster. You could use the command archive config to save in another location your last configuration file. Mo...

RKB04071984_2 · 09-17-2012

Hello,There are many reasons for it. Could you attach the configuration? After that maybe I can help to answer your questions.ThanksRonaldo

RKB04071984_2 · 09-17-2012

Hello,The simpliest series was the CSM, but it's out of order. Today you need to buy the ACE. There are two models. Standalone or service module. It depends on of your design and requirements.You would have more details about what you want. The ACE ...

Member Since	‎09-14-2010 11:50 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	9

User Statistics

User Activity

SFE/SGE IPv6 support.

slow network performance

Catalyst 2960 switch port bandwidth limit

Network documentation (for disaster recovery)

VLAN 1 is the only VLAN and its disabled

Server Load Balancing Hardware