About mdw

mdw · 09-12-2012

Hardware: RV082 V03Firmware: RV0XX-v4.2.1.02Lan: 192.168.1.0/255Static routing: 192.168.1.239 to 172.25.152.64/224The unit is configured as internet gateway. 4 NAT ports are active.When firewall disabled all works fine.When firewall enabled I do get ...

mdw · 01-22-2010

Hello,How can I configure the firewall of the Cisco 881W router so all LAN to WAN traffic is allowed?Preferably how to do it by use of the CP professional tool.So far I have configured the firewall with the CPP wizard and edited the Firewall Policy m...

mdw · 09-20-2012

By further testing today, we found that enabling firewall and disabling SPI "solved" the problem. Anyhow we would like to know why SPI causes the random problem?Maxim

mdw · 09-19-2012

Gabriele,V03 hardware has same behaviour. Possible workaround: enable firewall;disable: SPI, DoS, Block Wan, Rem. Managementand remove all custom Access rules (Restore to default rules).Maxim

mdw · 09-19-2012

Hi Johnnatan,The permit is in the default 3 rules i mentioned. See screenshotSo the problem is not solved. Remember that the problem comes randomly, sometimes it works.Maxim

mdw · 01-22-2010

Hi Jon,Could jou give the cli command(s) I need to enter to add GRE?Regards,Maxim

mdw · 01-22-2010

Jon,Is there a way to allow all protocol numbers from the in to the out zone and not just GRE (47) ...? (and how can this be done in CCP)Maxim

Member Since	‎01-22-2010 01:45 AM
Date Last Visited	‎06-04-2018 07:41 AM
Posts	14

User Statistics

User Activity

RV082 V03 Randomly connection lost when firewall enabled.

Cisco 881W - How to set in-zone to out-zone open?

RV082 V03 Randomly connection lost when firewall enabled.

RV082 disabling firewall AND remote management

Re: RV082 V03 Randomly connection lost when firewall enabled.

Re: Cisco 881W - How to set in-zone to out-zone open?

Re: Cisco 881W - How to set in-zone to out-zone open?