Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all!
I've successfully configured VXLAN support on ASA according official guide
(http://www.cisco.com/c/en/us/td/docs/security/asa/asa94/config-guides/cli/general/asa-94-general-config/interface-vxlan.pdf)
I have VXLAN-VXLAN routing and VXLAN...
Hi all!
I'm interesting is there any possibility to use one VSM module of Nexus V in multi-vendor environment.
For example i have virtualization based on Hyper-V with VMM from one side and VMware with vCenter and i want to have one point of network v...
Hi dear, colleagues.
I have small (as I hope) questions according redistribution between BGP and EIGRP protocols. I’ve attached scheme to this post. Please look at it and read describing.
I have three sites. On the first one I have internal networks ...
Hi, Neno
Thanks for your reply.
But unfortunately there is no such possibility to use clear command
#clear socket 404 ^% Invalid input detected at '^' marker.
I use 03.03.03SE installed on Catalyst 3850
Hi Rolf. Sure, I forgot mention that with less local-pref i use set weigh 0 as well. And yes, i've done some redundancy test - i shut down exterrnal bgp session in Site2 and got connectivity via EIGRP. From my POV this is only workaround while i'm ...
Hi Rolf, thank for your reply.
I know that using uniformed routing protocol is more preferable in any case, but at this moment i have that i have. I'm only try to find out reasons of such behavior.
Actually i drew only part of my big network In po...
