Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi GuysA Simple question When a AP is associated to a WLC, lets call it "WL0C1" and i want to move it to another primary WLC "WLC2".on the [High Availability] phane:Before:Primary Controller: WLC1 - 10.10.10.11No Secondary WLCafter:Primary Controlle...
true The AP's is placed in USA and i am placed in Europe, so that is not an option.i Will do it "the hard way" and reload all the AP's then they will join WLC2, and figure out what is the issue later, have to be done before the weekend i have 21 WL...
Hi Scotti think you are right, but i just cant figure out what is wrong in the setup atm.as soon the AP's is on the WLC2 with the new Software, and i want it back to the old WLC1, (after reload, and new software) it switch to WLC1 right away, as it s...
Hi ScottThat was exactly what i was expecting, but they only switch over to the other WLC when i reset them.maybe i should have told, that i have upgraded software on the failover WLC, and predownloaded the OS to the AP's on the "old WLC".the reason ...
Hi, you can try to set the gateway on NIC1 to the ip address of NIC2. (it is never a good idea to have a empty gateway on a WindowsNT).Or else you can try to make a route statement on your server.Example:route ADD 0.0.0.0 MASK 0.0.0.0 10.127.5.1 ...
