Hi!
I've a working config that allow internet traffic trought a firewall that is direct connected to 887 fa3 (vlan2 - public ip).
Now I would to connect a "guest" wireless network that has to bypass firewall; I've connected the eth of the access ...
It works Georg!
I'm writing you from the wireless client!
I've to add also "ip nat outside" on di0.
Now client has the pubblic address of the di0
All original lan sources behind firewalls are on B class 172.16, except "all" 172.16.2.0/24; for each la...
I will try and reply you in about 30'!
There's no client on vlan2, firewall nat anything with the 2 public ips for which I did the static route to logic ip of cluster fw!
if I nat on the dialer, I will nat also the vlan2 connections with the route...
Hello Georg,
this is the running conf with your suggestions:
version 15.1service nagleno service padservice timestamps debug datetime msec localtime show-timezoneservice timestamps log datetime msec localtime show-timezoneservice password-encrypt...
Hi Georg,
thanks for your reply!
I've tried your suggestion but still not working..!
From a win10 wireless client I can't ping the vlan2 ip nor 8.8.8.8, but I can succesfully ping vlan3
If I start "debug icmp" I can see only the packets to vlan3
With...
