Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys,I am confused I am trying to configure vlan access list in cisco 3750. But it is not working. Software version is C3750 Software (C3750-ADVIPSERVICESK9-M), Version 12.2(44)SE.Following is the configuration I tried and it was working in cisco ...
Hello Expert,I am having file copy slowness issue in uni-direction.Scenario isSite ASystem A -IP address 10.3.6.165 Site BSystem B -IP address 10.3.210.150Site A and SiteB are connected through 10G dark fibre and static route is been used to inter co...
Hi I am noticing a weird network issue. Scenario is when I try to copy file from a host in site A to a host in site B file copy is very quick. But when I tried to copy a file from site B of the same host to site A of same host file copy is very slow....
Hi ,I have a requirement to configure mtu size in cisco 6513 series core switch on SVI interface. I would like to know the impact to the other SVI interfaces and in general whether is it best practice to configure mtu on SVI interface or leave it to...
Hi When I execute write standby command from primary PIX it is not copying one particular command line to the standby secondary PIX the command is "nat (inside) 0 access-list inside_nat0_acl"even after rebooting secondary PIX I am having this issue. ...
Hi Dario,Since L3 ACLs wasn't working, I tried VLAN ACL. In my post I copied and past the config of L3 ACLs. I extracted that ACL after testing with 6500. I am not sure why it is not working?. Even after applying it is not blocking any traffic apart ...
yes I check that already, I changed it from Auto to manual 1000MB , full duplex no difference.I need some troubleshooting tips, since I feel saturated in troubleshooting this.
