Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Experts! Please help me with the some doubts about connectivity time. 2 months ago I did some ping tests and I got round-trip time aprox. 800ms between Host_A and Host_B:Host_A ---> Router_X (7609) ---> Router_Y (7609) ---> Host_B1 week ago, I ins...
Hi Guys!!! I need your help please. I have a Router 12404/PRP (IP=1.1.1.1) and I'm trying to connect it to a Traffic Analiser (IP=1.1.1.2) in order to send flow records. When I connect the Router directly to Analiser without VRF configuration [Case-1...
HSRP behaviourHi experts! I have an HSRP configuration between PC-Linux and 2 routers, and this is the configuration:ROUTER-1interface Vlan10 ip address 200.25.192.18 255.255.255.224 standby 110 ip 200.25.192.17 standby 110 timers msec 300 1 standby ...
Hi experts! I have a Switch Cisco WS-C6509-NEB-A and I need to do some test to proof redundancy between slots with the same kind of cards. I have 2 WS-SUP720-3B, 2 WS-X6516A-GBIC and 2 WS-X6148A-GE-TX:SW#show moduSW1#show moduleMod Ports Card Type ...
Hi Experts! I am trying to configure bandwidth control (only ICMP) in a ROUTER but in "both" ways. From PCA to PCB I want to configure 200K, and from PCB to PCA I want to configure 400K. This configurations are done because I want to avoid excessive ...
Hi Jeremy.If you want to upgrade the IOS you have to check this link, but be careful of the directory where are stored the IOS:http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_example09186a00807714cb.shtml#native
Hi Jeremy, in my case I have the IOS in the sup-bootflash. The primary card is in slot 5, and secondary in slot 6. You can execute the following steps:(Primary Card)SW#show sup-bootflash:-#- --length-- -----date/time------ path1 74637284 Aug 12 2...
