Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,We are going to buy a firewall, but little confused in whether to choose ASA5510-SEC-BUN-K9 or ASA5520-BUN-K91. Does ASA5510-SEC-BUN-K9 support HA both active/active & active/standby ?2. The memory avaiable in ASA5510-SEC-BUN-K9 is 256MB, is ...
Hi,Our current scenario is, we have a Router-A cisco 2821 that is connected with two ISPs in multihoming configuration through BGP, so that if one ISP gets down the other takes over, we are receiving just a default route from our ISPs, and PIX 515E h...
I have cisco 2821 router with 16 FastEthernet Switching module. I am facing a problem that at console a message "Insert multicast address to MARL table failed" appearing constantly. I tried to search it on Internt but could not get anything usefull. ...
Kindly See the attachmentWe have a PIX firewall in front of our application server and assigned application server an internal IP address. We configured PAT to allow our clients to get Internet access and configured static NAT entry to map one of the...
In your scenario, as you are connected with two different ISPs, relevent registrar can assign your organization a /24 address space. you will have to apply for Multihoming assignment, I think they charge membership fee and address space fees as well....
Victor,I think I couldn't convey my point 1 correctly, let me explain it to you further.We are connected to ISP-1 physically through Optical Fiber link and with ISP-2 through DSL.Both ISPs have assigned /30 address for our router interfacePurpose of ...
Thanks for both of you Jon & VictorI am thinking on one more scenario, if I can get guidance on it as well, if we change our scenario as shown in the picture below1. in this case if we configure Router-B in some passive state, so that if Router-A get...
Thanks,Following is the output of first few lines of show verCisco IOS Software, 2800 Software (C2800NM-ADVIPSERVICESK9-M), Version 12.4(1a), RELEASE SOFTWARE (fc2)Technical Support: http://www.cisco.com/techsupportCopyright (c) 1986-2005 by Cisco Sy...
Thankyou for this replyBut if I don't have the DNS server what is the solution, is there any way I can access my server using IP address not DNS nameRegards,Faraz Ahmad