Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi AllI have the following problem:we have two offices that are connected with VPN. Office 2 has a server users on office 1 use. Office 1 has remote users that connect using a VPN client.Users in Office 1 working under NAT communicate with the server...
Hi AllI would like to place a web server behind the NAT and get to it both from the outside and from the inside using a public IP address. I used static NAT in order to do that.It works well from the outside.Private users behind the same NAT can not ...
Hi.I'm installing a WIC-1ENET on a 1750 router that seems to follow all the Cisco guidelines and still get the following:"00:00:08: %PQUICC-1-UNKNOWN_WIC: PQUICC(0), WIC card has an unknown ID of 0x39"The card is installed on port 1 which is OK with ...
Hi.I need to set a computer on the DMZ so it has a static routable address, that together with runing NAT on the same router. I use a 1750 with 1 T1 card. Is that possible?Thanks in advance.Amir
Hi There.I am looking for a way to map a host on the LAN side to a WAN IP directly so that all requests to all ports on this IP address would be routed to it. All that on a Cisco 1750 that runs NAT for the rest of the network.ThanksAmir
Hi FedericoI am sorry I was not clear. The remote client is on the road or in a totaly different location and public IP. IE there is a remote user, Office 1 and Office 2.The remote user uses vpn client to connect to office 1.ThanksAmir
Hi GeorgI have a fastethernet for the LAN (Behind NAT)a serial for the internetI also have a ethernet for DMZ.Please find the configuration following (I omited or replaced some ip adresses):version 12.3service timestamps debug uptimeservice timestamp...
We have 12.2(17)on a cisco 1750 (MPC860) processor (revision 0x601) with 36864K/12288K bytes of memory.Do I have to get an IOS upgrade before the Card would work?ThanksAmir
Thanks Gary.I thought I won't have a way out but purchasing a WIC-1ENET card. We run NAT and ACL as our form of protection. Do you think this is not secure enough?If anyone has an example of setting such a scenario it would be welcomed. Thanks again....
