Dears,Can I shutdown all unused ports at Cisco switches by Netconfig or other tool at Cisco Works managment too?I have 300 LAN switches and I need to block all unused ports automatically.Many thanks.

Dears,How can I get traffic analysis report (Graphic) for our routers WAN interfaces utilization from CiscoWorks LMS 3.1?

Dears,I need to apply a policy that for any new router or switch installation, specific configuration will be sent to these devices through one centralized TFTP server which comply with our configuration and rules, this is to avoid any miss configura...

Hi,I have the attached network, I need to run ebgp with our ISP and perform load balancing on two 1G link Ethernet connections, how I can do that without looping problems, bear in you mind that our internal routing protocol is OSPF.Appreciate the exp...

Dears,I have a Point Of Sale Terminal at the remote side, this POS dialing a PRI and connected to one of the PRI channels at the router, after that this POS needs to send a message to the payment server over specific TCP port for payment authorizatio...