Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Could any of you please tell me why I don't see the bridging related commands on IOS XE 16.6.6 (C1116-4P, IP Base) ? C1116-4P(config)#interface Ethernet0/2/0
C1116-4P(config-if)#bridge?
% Unrecognized command
C1116-4P(config-if)#interface GigabitEthe...
Hi community, I'm trying to achieve the following. Could anybody tell me what has to be configured on the router running IOS 15.5? 1. Interface Vlan72 receives IGMP Membership Report from end hosts in the segment.2. The router populates its MRIB with...
Dear community,
Currently I'm trying to implement what is described in the following documentation – to let CSR modify VPC Route Table, taking over a route usually forwarded to another CSR, in case of it's failure.
Cisco CSR 1000v Series Cloud Se...
Dear Community
I'm currently looking for a router platform, which should be used as a home gateway on 400 Mbps broadband access. Until now, my 880 Series ISR (C881-K9) has been working very well, but due to its limited line rate (100 Mbps), I'm con...
Hi @scidoner, Thank you for your reply. Unfortunately though, I don’t remember what the issue was, nor have I the bridging configuration in place anymore. But if you see the command service instance being accepted where you need, I don’t see any reas...
Dear Georg,I tried configuring the bridging on the C1100 platform again – Turned out, that I hadn't read the documentation you suggested as I should. Bridging is now working and I'm very grateful for your help. Thank you so much!ip-100-127-11-11(conf...
Thank you Georg, I tried it and it seems like working, except for the VDSL2-Interface (Ethernet0/2/0) or the integrated switch. As I originally intended to bridge between the VDSL2-Interface and a routed interface or a Vlan interface, it didn't achie...
Thank you very much for your comment, but unfortunately it doesn't seem to work...C1116-4P(config)#bridge 1 protocol ?
dec DEC protocol
ibm IBM protocol
vlan-bridge vlan-bridge protocol! missing ieee
C1116-4P(config)#bridge ...
