Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,As mentioned you will get a more rich experience and fully featured SD-WAN using an MX.However, if all you’ve got is an MS250, I will note one feature you might be able to leverage, which would be ECMP routing.If both upstream gateways can run ...
I would like to clarify the distinction between the STP event and the link event to remove any confusion.When a switch port experiences a loss of PHY (link goes down), it is at this point that STP also "disables" the port. In other words, the meaning...
You will want to make sure there is an IGMP Querier active in each VLAN where multicast flows will be passing through. When an L3 interface is set to enable "Multicast Routing", this interface will also run an IGMP querier, so for VLANs where multica...
This is not possible. However, if you have two MS350s configured either using warm spare (VRRP) or in a switch stack, DHCP leases will be synced among them for failover purposes if you run a DHCP server.
Hello,You are correct. A switch treats a received multicast packet as unknown when the destination group is one for which the switch has not observed an explicit group join (signaled via an IGMP report packet).If flood-unknown is enabled, such packet...