About christensen

christensen · 12-04-2018

I have CUCM 11.5 running on a virtual machine, and have 8841 phones. These run SIP only. Both are the exact same model and firmware and are setup with the same profile in CUCM. When a call is made, the called phone rings, and can be answered, but n...

christensen · 05-23-2018

I have ISE 2.3 and a cisco router. ISE has the router network device configuration set to use SNMPv3 with auth/priv. The router is setup with auth/priv and is able to communicate with the NMS just fine using SNMPv3. When ISE sends an SNMP get, the r...

christensen · 05-11-2018

I am trying to integrate an APC PDU to authenticate with RADIUS on ISE. This requires a vendor-specific attribute to be set. I created an APC dictionary with the attributes, and an APC profile that uses the APC dictionary. The PDU network device is s...

christensen · 05-14-2018

Thanks for the answers. I finally got it to work. ISE 2.3 is picky about for Auth. profiles; I had to try several different things several times before it didn't give me a Auth. Profile not found when trying to authenticate.

Member Since	‎05-11-2018 10:46 AM
Date Last Visited	‎12-11-2018 05:15 PM
Posts	4
Total Helpful Votes Received	2

User Statistics

User Activity

Call setup wont complete

ISE profiler using wrong SNMP v3 USM

ISE RADIUS VSA question

Re: ISE RADIUS VSA question