Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm in the process of setting up a T1 point to point connection between an office and colo facility. There are Cisco 2801 routers on both ends. I'm not getting a carrier detect light. I was thinking perhaps a circuit issue, a clocking issue, or so...
I'm attempting to set up ssh in lieu of telnet on a 2801 router. It's running IOS 12.4(16a).When I enter in this:Routername(config)#crypto key generate rsaI get this error: "Invalid input detected at '^' marker."What am I doing wrong? Thanks.
Hi,I'm setting up a Cisco 2800 series router for use with two T1s (bonded). With the config below (all IPs altered a bit), if I plug a laptop into the FE0/0 port to test (with a public IP address from our 12.187.222.x block) , I can browse the web f...
I'm working on a config for a 2801 router with a dual WIC. (There is another single WIC installed, but it won't be in use for awhile). This is for a 2xT1 - 2 separate handoffs. Do I have this correct? I'm feeling doubtful.Info from our ISP (IPs a...
Looking for a recommendation for a router purchase at a colo site where we'll be putting in a private line back to our main office. The colo hosts our web server, and so we will also be using IP transit services provided by the colo facility so the ...
Jon,That was exactly it. Thank you.I downloaded the ipbasek9 .bin, and was able to upload that to the router's flash dir. However, I wasn't prompted to overwrite the contents of flash, and after reloading, the router still shows it's running the c2...
Thanks for taking a look Collin, and for the clocking suggestion. Idid confirm that our ISP provides clocking, so I will make that change on the router.
