Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,I have a very strange VPN issue that I cannot get to the bottom of... Hopefully someone can provide some assistance.The tunnel comes up fine, phase 1 and phase 2 complete successfully, but no traffic passes over the tunnel. This has been an...
Hello all,I have SSL VPN connectivity up and running on several ASA's, but I don't want my users to be able to login from anywhere or from any pc. I would essentially like to disable the clientless aspect of SSL VPN so that users can only login if th...
Hello all,I need to upgrade the licenses on a failover pair remotely and have a few questions. I was following the guide at:http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a00806b1c0f.shtmlbut it doesn't seem to have gone...
Hello all,I don't personally use the ASDM and so have little experience with it, but I need to get it working for others to perform basic admin duties.I am running 8.0(5) and ASDM version 6.1(5) on all firewalls, and it is working without problem on ...
Hello all,I have a 6509 that the CPU usage spikes on every 15 seconds or so. The kernel process goes up to nearly 100% then drops back down to it's baseline 20%. The switch is currently only servicing 6 x 4900M switches, 2 blade switches and 2 san sw...
Hi thanks for the reply. Config on the other end is good, the sa looks exactly the same with encrypts but no decrypts.The correct no nat are definitely in place both ends, aswell as everything else that is required. I've reconfigured it many times at...
Hello,There is no way to do this without breaking the failover, but there should be no downtime involved.Just apply the new license to both (after applying to the first you will get the message stating that failover has been disabled). You should the...
How do you connect to the primary unit remotely?If you are using the ASDM and connecting to either the outside or inside interface, do a "sh run int" and get the standby ip associated with that interface and you should be able to manage the secondary...
What version of Java are you using?The latest stable version of Java I have found for ASDM use is jre-6u7.http://java.sun.com/products/archive/j2se/6u7/index.htmlGive that a try.Chris
