Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have two WLC 2504s in production with software version 8.2.170.0. We just purchased an addition 2702 AP and I successfully joined it to the one WLC. However, I needed to install the AP on a different subnet then the one I configured it on (the WL...
I have installed a new second WLC 2500. In an attempt to join an AP 2700 to the new WLC I configured the primary controller in Wireless > [The AP] > High Availability tab. After doing this the AP lost connection to both the new and old WLC. I then...
The solution was to reset the controller using the cli: I ran the following commands.debug capwap console clierase /all nvram:undebug allreloadclear capwap private-config Using the MODE button or just erasing/reloading the nvram would not fix it. I...
The Country Code is set to United States on both WLCs. The strange thing is that the AP initially joined. I configured it in my office which is in a different building and a different subnet. I then took it over to the building to install it and wh...
Thank you for the reply. I am using DHCP option 43 and that seems to work fine. The AP finds the WLC. Here is the boot process and how it just keeps failing to join. =~=~=~=~=~=~=~=~=~=~=~= PuTTY log 2019.11.05 16:38:15 =~=~=~=~=~=~=~=~=~=~=~= IOS B...
Thank's for all the help. I will update the WLC software and see if the APs can join the new controller. Interestingly, I was able to get APs back on the first controller. After resetting them they would not join. They finally joined, but I don't ...
Could this be my problem?Our current WLC on the 10.5.1.x subnet is version 8.1.102.0The new WLC I installed (that none of the APs can join) on the 10.70.1.x subnet is version 7.6.120.0.The AP version is 8.0.115.0.Is an AP unable to join a WLC with an...
