Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi
I am trying to Power a Cisco 1562D wireless access point with a POE adapter.
It works fine connected to a switch and I have found two recommended POE injectors
AIR-PWRINJ-60RGD1AIR-PWRINJ-60RGD2
Does anyone know of any indoor style adapters/inje...
Hi
Just a question regarding the WLC 2504 and Cisco 1562D.
Can you have 2 x cisco 1562d's operating as a bridge between two buildings and also have an ssid enabled for users to connect to outside?
Regards
Hotline
Hi
I am trying to configure 2 Cisco 1562D Waps as Flex+Bridge Mode but cannot see the option for Flex+Bridge.
Is there anything I need to do to see this option.
Currently the two Waps are MeshAP waps in Bridge mode.
Do I need to change one to...
Hi
I have some questions about a wireless setup.
I have a wireless lan controller 2504 and have two wireless cisco 1562's
The Wireless Lan controller is on firmware 8.5 along with the WAPs.
I will be connecting the WAPs, one as a RootAP and the o...
So then my understanding would be that I can set the two access points in Bridge mode and set one to RootAP and the other to a MeshAP and if the controller goes down then they will continue to bridge traffic across the network.
Would it be correct in...
So I would need to configure a RAP and a MAP or two RAPs and would the option then appear in the settings or would I need to select Flexconnect mode for both and then Flex+Bridge mode?
Another question if you can help me is If I have a RAP and MAP ...
Hi
So in regards to a bridge rootap to meshAP setup.
If I have a spare internet conneciton and another backup server doing dhcp and radius , If the wireless controller goes down would the bridge still work for a certain number of days or would it l...
