samador382

@Jasmus I could not run the mls qos command. It is not recognized on this switch. Perhaps because it...

Here is a little more info to better understand my environment. That MAINSWITCH has a few VLANS on i...

I ran this command and the laptop connected to directly to port 48 on the MAINSWITCH still does not ...

@casanavep I plugged a laptop into port 48 on my main switch and it is not getting network access. W...

main switch 3560 show vtp stat VTP Version : 2 Configuration Revision : 15 Maximum VLANs supported l...

sh interfaces trunk Port Mode Encapsulation Status Native vlanFa0/1 on 802.1q trunking 1 Port Vlans ...

Yes, you are correct. There is a default gateway configured. Will I need to add that manually to the...

Everything except the auto qos voip cisco-phone command worked. Not sure why. It is not required but...

I would like both phones and workstations to be plugged into the 2950 switch.

I plugged in a laptop and it is not getting network access. Is there some other configuration that I...

Also, MAINSWITCH-Sw1#show run interface fa0/48 Building configuration... Current configuration : 262...

Looks like the output went through. Here are the results. MAINSWITCH-Sw1#conf t Enter configuration ...

So is this the command I am running altogether? conf t interface FastEthernet0/48 shut description T...

Never mind I got it show version Cisco IOS Software, C3560 Software (C3560-IPSERVICES-M), Version 12...

What do you mean?