With those commands in place - assuming that there's a DHCP server active on VLAN 30 (or a relay / ip helper-address command) you should be good to go at this point. If there's not a DHCP server, you'll have to statically address.
A lot of this is ba...
Looks good! If you run the show interfaces trunk command from before you should see that the interfaces are up and appropriately passing VLANs now. The srr-queue configuration that was generated is from the Auto QoS feature, so that went through ju...
Well, a lot of that's already done, it's just the trunk configuration and auto qos that didn't "stick" before..Try:
conf tint fa0/48shutswitchport trunk encapsulation dot1qswitchport mode trunkauto qos voip trustno shutendwrite memSince it looks like...
Enter
Switchport trunk encapsulation dot1qauto qos voip trustswitchport mode trunk
Rather than the commands:
switchport encapsulation dot1qauto qos trustswitchport mode trunkShould get you where you want to go. Now, here's the rub - this will allow...