Hi,
I have CME on cisco 2901 router, cisco phones 7945 and 6921. miss call are displayed on 7945 but not on 6921.
IOS c2900-universalk9-mz.SPA.154-3.M4.bin.
what I should do to make miss call appear on 6921 ? (attached show flash and show version)
...
Hi,
I am new to CME, I have two offices (located less than 100 meters) both offices have CME 2900 series Version 15.2(4)M3 and more than 40 phone extensions.
I have one cable to connect between offices.
office 1 : phone extension starts 201
office 2...
Hi,
I am new to configuration of CME, requesting your kind help for scenario below:
we have new branch to open, we have 3 analog lines:
line 1 : 4444444
line 2 : 5555555
line 3 : 6666666
we have cisco 2901 with CME license and cisco 2960 switch.
...
Hi,
Yes its resolved, I have involved cisco TAC, they did debug voice ccapi inout and found issues with cable connecting from analog provider to CME, replacing cable solved the issue.
thanks to all
Hi, I have applied the configuration and I have one more issue.
if I call manager or secretary or all and hang-up the phone it continue to ring and never stop.
plz plz plz help in this issue
config:
ip dhcp excluded-address 10.10.10.1 10.10.10.20
!i...
Hi, I am not sure if dail peer configuration is correct also I have added comments in blod
voice-port 0/0/0 supervisory disconnect dualtone mid-call timeouts call-disconnect 5 timeouts wait-release 5 timing hookflash-out 50 connection plar opx 201 "t...
Hi
I have created configuration for CME and I could not full CoR, can you please help in this:
my numbers is 7 digit and some cases its 3 digit (when calling ISP)
ip dhcp excluded-address 10.10.10.1 10.10.10.20ip dhcp excluded-address 10.10.11.1 10.1...