Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,My outdoor AP 1552 is unable to join WLC 2504 below are the log messages i am seeing on the console of AP.*Jun 24 09:19:12.107: %CAPWAP-3-ERRORLOG: Could Not resolve CISCO-CAPWAP-CONTROLLER*Jun 24 09:19:22.107: %CAPWAP-3-ERRORLOG: Go join a capwap...
We have catalyst 9800 WLC and we have 9120 series ap`s which has already aironet firmware, when connected with new WLC after dicovering the controller when it sent the join request we are receiving CAPWAP State: DTLS Teardown message, following is t...
Hi,
we have Cisco Catalyst 4500 Series Switch at our distribution layer with VSS configuration, problem we faced last time is our second switch in VSS goes down all the devices connected with the switch got disconnected but the switch is power up and...
Hi,
Previously we have Cisco 2504 controller where we configure our AP with primary and secondary controller IP addresses. Now we have Cisco Wireless controller 5520 configured with SSO redundancy mode in our network, In our new setup when AP reboots...
Hi,
I have implemented router on a stick configuration for my two VLAN in the network. I want to limit bandwidth up to 1 Mbps for my VLAN networks, therefore i configured class-map and policy map on my Cisco 1941 router. By using "service-policy ou...
We have 6.10 firmware running on controller that`s the reason AP is not joining, for 8.9.111 firmware on AP we should have 6.12 firmware on WLC so we need to upgrade the controller.
The Controller and AP are compatible that i checked already, as of now ap has an aironet firmware 8.9.111. Should AP get the new firmware and configuration file from new controller ?
Hi Reza,
We did not contacted Cisco yet, about IOS upgrade we are not planning any now.
Show virtual switch output is as follow.
DIST_VSS_SW#show switch virtual Executing the command on VSS member switch role = VSS Active, id = 1Switch mode ...
Hi Leo,
The complete output of show version is as follow
DIST_VSS_SW#sh version Cisco IOS Software, IOS-XE Software, Catalyst 4500 L3 Switch Software (cat4500e-UNIVERSALK9-M), Version 03.06.06.E RELEASE SOFTWARE (fc1)Technical Support: http://www.ci...
