Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Amikat says all.
Consider also default parameters:
When port security is enabled, the default maximum number of secure MAC addresses is 1 (as already said) and the default violation mode is shutdown.
The violation possibilities are: restrict (drops ...
Hi
Try to post the output of the 'show mac-address-table dynamic interface g1/0/45' before enabling the port-security
What's the state of the port after you enable the port-security (and the AP becomes unreachable)?
Try to post the output of the 'deb...
You can also reset the SPA via phone.
Plug your analog telephone into the phone1 port.
Pick up the phone, press 4 times the star key and the code 73738 followed by the # key, then press 1 to confirm and hang up.
The SPA will reset to factory default.
In ethernet stantard, the transmission uses only 4 of the 8 pins available (the 4 unused pins are needed for power supply in PoE).
1-2 for the tx and 3-6 for the rx on both sides.
If you want a crossover cable you need to invert 1-2 with 3-6 on one s...
Cisco 2960 switches do not support the encapsulation command.
Can you post the following outputs?
show vlan brief
show run interface fast 0/20
show vlan id 104
show vlan id 117
Clearly your vlans should be configured on the interface connected to the...
