Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
But what happens if you use a hub instead of a unmanaged switch? No bpdus, so the loop is guaranteed. I think, in these cases the best option is to use stp loop guard along with storm control.
The complete commands are:
class-map inspection_default match default-inspection-trafficpolicy-map type inspect dns preset_dns_map parameters message-length maximum 512policy-map global_policy class inspection_default inspect dns preset_dns_map insp...
Finally I found the solution.As Cisco says, Cisco 7200 doesn't support fully ikev2 configuration.Nonetheless, you can configure flexVPN DVTI using tunnel mode gre ipinstead of tunnel mode ipsec ipv4 on GNS3.I tested my topology using csr1000v (on GNS...
Finally I found the solution.
As Cisco says, Cisco 7200 doesn't support fully ikev2 configuration.
Nonetheless, you can configure flexVPN DVTI using tunnel mode gre ip instead of tunnel mode ipsec ipv4 on GNS3.
I tested my topology using csr1000v (on...
Hello.
Using standard GNS3, ikev2 only works using 7200 series Routers.
But IKEv2 is not supported on this router (at least, this is what Cisco says).
Nevertheless, using GRE over IPSec this works fine (changing tunnel mode ipsec ipv4 by tunnel mode...
