Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I would like encrypt certain traffic. Can my current HW support an image that would allow me to do this? IF any, besides upgrading the image, what else would you upgrade?Thanks in advanceSystem image file is "flash:c2600-i-mz.120-8"cisco 2610 (MPC860...
I have a working vnp tunnel. I can access only the local lan connected to pix inside_if. Wins is working fine and I can browse using netbios. The issue i have is that i cannot access other networks or subnets beside the one that is connected to pix. ...
This is the pIX515 current config for the remote access vpn using client 4.02a. I am not able to make the vpn connection to the headend device. **************pix_config***********access-list vpn_clients permit ip 192.168.0.0 255.255.255.0 192.168.1.7...
PIX v 6.3, I had to use the np63.bin password recovery to regain access to the FW. When the firewall reboots and wr term is executed, I still can see the following in the config after instructing the recovery tool to erase the commands. enable passwo...
Thnks,I have the 2610 and will be purchasing additional memory. I will use an ipsec with des or 3des to encrypt the traffic depending on the performance. I also have rip running on the routers and would encrypt the entire traffic between sites.
yes, they share interfaces in the same subnet(192.168.0.0/24) and the router's default gateway is the pix's inside_if.I can see the all other subnets with sh route on pix via rip.from the vpn clients, I can only access (192.168.0.0/24).Thanks
