Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi people,I'm trying to configure a second vlan on my router.That worked, but I can't find the commands to attach 2 of it's interfaces to this new vlan.I would expect switchport access, but the newest ios doesn't give me this option.I've put c850-adv...
Hi all,I've made some config changes on one of our routers and after those changes telnet sessions to the router are no longer accepted.Here's what I did:I've added a vlan5, gave it a public ip address.I then gave fastethernet port #3 switchport acce...
Hi All,I'm trying to figure out a problem on a 5505.I've created a static mapping and adjusted the acl on the outside interface to accept traffic for the public ip address in the mapping.When I run the packet-tracer to verify if traffic is allowed to...
Hi,We are currently using CACTI to monitor traffic through an ASA.At this moment we can only graph 2 interfaces: inside and outside.Is it possible to monitor single ethernet ports?Has anybody already done this and can you supply me with an example co...
I'm trying to reconfigure a 3550.I've connected the familiar blue cable to the switch and I'm getting all the familiar text on my screen.However, after it tells me to "press return to get started", I hit the return button and the text just scrolls by...
Hi folks,Thanks for the speedy answers so far.Access-list 12 contains multiple ace's with multiple public ip addresses which our company uses. My ip address falls squarely into those acl's. I have removed the access list from the line, no joy there e...
The issue has been resolved.The ip address this trace was going to has been configured on a new interface. This interface had not had a nat statement added for it.That was step one.The adjacency error may have been resolved this way, or this happened...
