Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, my purpose is to have two ISP connections for to have connection failover for my public server.I have a web server and mail server and I would that when primary ISP connection is down automatically my public servers are available with second ISP ...
Hi, my purpose is to have two ISP connections for to have connection failover for my public server.I have a web server and mail server and I would that when primary ISP connection is down automatically my public servers are available with second ISP ...
Hi, I have a problem with restore config on Cisco ASA5505, on the first 5505 I have made a config backup form the GUI:tool --> backup configuration --> backup allnow on the second ASA5505 (with the factory value) from the GUI:tool --> restore configu...
Hi, I have a tunnel vpn site-to-site with two ASA5505, the tunnel is up but when I try ping between inside lan I have in log file:Teardown ICMP connection for faddr 192.168.0.100/0 gaddr 192.168.1.159/512 laddr 192.168.1.159/512 Built outbound ICMP c...
I would like to VPN between SA520 and ASA5505 but I have a doubt about ASA configuration for Host/Network that I must specified on step 5 (with ASDM software), I have find on "Cisco ASA5505 getting started guide" on chapter 8:Traffic flow to be prote...
Hi, my purpose is the management of fail-over of my primary line connection (primary ISP), for now the load-balancing isn't requested.For our webserver and smtp server I use our primary name server and secondary name server, the target is when the pr...
Hi, I have tried with 'Save' and 'write memory' but with both command the configuration isn't changed, then I have used the CLI with tftp server and the restore procedure is ok ! but with GUI the problem is always present.Thanks.- Salvatore.
I have done reset to factory default valuse and then I have made again all configurations (as the last configuration I sent to forum) and now I do ping with success but unfortunately I understand why in the first configuration I could not ping.Than...
..pheraps the problem are the static route ? I always used vpn based on openswan and in the site-to-site configuration is needful the parameter:leftnexthop=x.y.y.zthis ip address is the ip assigned to router.In cisco ASA configuration I have:route ou...
