Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello EveryoneI am in the process of moving my enterprise from a hub and spoke layout utilizing privdate T-1's and EIGRP to an MPLS setup using BGP.I have a branch office that I am trying to move over this new setup and I cannot get it to communicate...
All,I have a Cisco ASA 5510 with an IPS module in it. When trying to connect to this unit with ASDM on port 8443 I get an error "Certification Validation Error" and on the popup it is asking for the password. I put in the enable password and then it ...
Edison,I have implemented the commands that you have given me and I can access the local server resources at my data center now but I cannot access the internet from the pc's at the remote site. My internet connection is at my data center and comes o...
marwanshawi,The 192.168.5.0 network is at my remote site.I did have synchronization enabled on my data center router but have disabled it.here is the output of traceroute from the remote site router to 192.168.6.9traceroute 192.168.6.9Type escape seq...
marikakis,When I setup EIGRP on the remote router again would I setup it only for the remote network instead of all 192.168.0.0 0.0.255.255 networks like it was setup before?Thankstld
Edison,Here is my sh ip bgp from the remote routersh ip bgpBGP table version is 43, local router ID is 192.168.5.1Status codes: s suppressed, d damped, h history, * valid, > best, i - internal, r RIB-failure, S StaleOrigin codes: i - IGP...
