Hi,I'm a Cisco newb. Was wondering if an 1811 has a built in IDS? And if so, can someone point me to any documentation? I only have the attached file. Not sure if this is the correct one.Appreciate it!Thanks,O
Hi,My client will be moving to a new office and we plan to have two Internet sources. How can I make both of them work with my 1811 router and also have load balancing. I am running IOS v. 12.4.Thank you for your help.Oliver
Hello,Has anyone had experience on the 1811? I have installed one and from then on I could not print to my network printers. I can still ping the printers but when I send print jobs, they do not respond.Thanks!Oliver
Hello,I'm not very good at navigating through documents on this website but can someone tell me if the Cisco ASA 5510 can be used as a router and firewall OR if there is a link on its documentation. I appreciate your help!Thanks!Oliver
Hi all,Im getting some funky characters when booting my Cisco 1750.â¬Ëâ¬Ã¦â¬Ëâ¬Ã¦â¬ËÃâ¬Ëâ¬Ã¦â¬Ëâ¬Ã¦â¬Ëâ¬Ã¦â¬â¬Ëâ¬Ã¦â¬Ëâ¬Ã¦â¬Ã¸Anybody know what's going on?My router does not boot to the IOS. Last command I gave it was confre...
Guiseppe,Thank you very much for this comprehensive guide.I will have a chance to test the settings next week.You have described WAN1 and WAN2, which is perhaps the FastEthernet 0 and FastEthernet 1 respectively on our router, is this correct?Oliver
How can I accomplish this? I understand that by default, even if it is not showing up on the running-config file, there is an:ip route 0.0.0.0 0.0.0.0 x.x.x.x where x.x.x.x is the IP address of the routerPlease correct me if I am wrong.Thanks,Oliver
Reading about ip helper address, it is saying that it is needed only if your accessing an IP on a different subnet. However in my case, all computers and printers are on the same subnet. Do I still need to add the ip helper address? I am a bit confus...