Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hy everyone ,Im having a bit of a doubt , i managed to configure a failover interface but im having problem changing my dynamic NAT from the inside interface , instead of outside it should be outside2 wich is my bkp interface , if i change it the in...
Dear Friends , Im trying to configure a cisco asa failover , here is my scenario .OUTSIDE - 10.10.10.2 + DEFAULT ROUTE TO 10.10.10.1BACKUP - 192.168.0.2 + DEFAULT ROUTE TO 192.168.0.1 INSIDE 172.16/12In my OUTSIDE interface are all my firewall rules...
Hello , Im trying to use VPN Anyconnect client , but i can`t access my local network when im connected to the vpn , i can access the internet and my dmz , i already tried slipt tunnel , and nat exempt rules to access my inside net but no sucess . ...
Hey Manish , Thanks for your reply , i do have 3 netblocks /24 but they all came trough the same ISP but with different routes and i also need uptime , thanks for your configure example and the explanation . Cheers , Paulo
Hey , I managed to get it to work , but what about my dynamic nat rule wich translate my inside address trough the outside interface , and my static nat rules also in my outside interface . Thanks ,
Here says ASA 5505 can have 25 clients http://www.cisco.com/en/US/prod/collateral/vpndevc/ps6032/ps6094/ps6120/prod_brochure0900aecd80402e39.htmlIn Configuration -> Remote Access -> Advanced -> Maximum SSL VPN Sessions , i type 10 and an erro popsup ...
