Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys,
I came across an issue where a "Command Authorization Failed" error would pop up in a device upon issuing ANY command, including exit. Turns out it was short of just 2 rows of configuration which was the following:
tacacs-server host 10.X.X...
Hi there, I have a fairly simple but peculiar problem at hand. A device with a static IP located on an access port on an L2 switch which trunks back to a router with the same vlan interface. Show mac address-table on the L2 sw shows that the mac addr...
You can pretend nothing happened.I came back to work this morning and everything was working fine. Ah~ the wonders of networking. Thank you very much for your help though. I appreciate it.
Hi Richard, Thanks for your answer.It's a bit hard for me to troubleshoot from the device end as it is not a computer and we not permitted access to it, it's managed and configured by some other team/department, so I cannot answer your question wheth...
