Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I have raised a support ticket but worth putting a question here as well in case anyone as seen this.We are changing our ISP to a new MPLS provider who use HSRP (some sites we have two routers and lines so this is the preferred configuration)....
Hi,Sorry for the "black ops mode" was away.So the issue is solved and it just highlights my lack of detailed network knowledge i'm afraid.I was not able to ping the ISP routers either directly connected via laptop or using a dumb unmanaged switch. Al...
Hi Adam,sorry i missed your post.at it's most simplistic, we have a MPLS line going into a site, the router is setup with HSRP but with one interface that will connect as a trunk port into the Meraki switch (obviously with the correct network setting...
Hi,thanks for the clarification, confirmed the Vlan ID, Subnet and mask are correct on the Cisco router and the Meraki Vlan. It is on three switches i have tested across two sites (Networks), so must be a configuration issue but just cant see it.I ha...
Hi,yes we was on a call for around 90 minutes trying to solve. the best i got was some entries in the ARP table showing the ISP router interfaceI was reading up on HSRP and it looks like it needs Multicast to communicate to the other interface, the M...
Hi Adam,Yes thats right, its Private but it does have a FW at the end (which is not commissioned yet)The Default route for the Meraki devices is still the current ISP (another private MPLS) with a FW and we have obviously been using for some time.Tha...
