About tramseyG4S

tramseyG4S · 06-09-2023

I'm using a Catalyst 9300 series with IOS XE 17.06.05. Inside of "banner exec" I'm trying to use variables / tokens to confer that info to the users. Specifically, i'm trying to use $(line-desc). Example: "banner exec * You are logged in on line $(li...

tramseyG4S · 07-14-2022

Hi there, I think that I've self-solved or identified the solution to my problem. And I think I'm writing this discussion thread more to just literally write down my own thoughts and discoveries. Though, I'd otherwise appreciate if anyone can confirm...

tramseyG4S · 03-21-2022

I been using a workaround to overcome the limitation of a non-cisco network router that I have (which can't do OSPF). It connects to a Cisco based network which uses OSPF. But, I can't use that workaround anymore. So I need a new workaround or hack. ...

tramseyG4S · 07-17-2023

Well... It's been a while. So much has happened since I first started this thread. Unfortunately, it's sad to say, I've never got around to trying to work on the PBR solution to the quandary laid out. The hack of supersizing the loopback networks wit...

tramseyG4S · 06-15-2023

For anyone that ends up on this in the future from a google search - I found the answer.$(line-desc) is configured with the command: locationSo, enter config mode, switch to your line: con 0 or line vty 0 4 (or 15, or whatever). And then type: locati...

tramseyG4S · 06-12-2023

I did some further experimentation this morning. I typed in all the banner tokens listed then additionally some I didn't expect to work. banner exec * You are logged in on line $(line) of $(hostname) on $(line-desc) in $(domain). With ($peer-ip) and...

tramseyG4S · 07-20-2022

@MHM Cisco World wrote:sh cry isa sa detplease share the output of this command There are no IKEv1 SAs There are no IKEv2 SAs Declaration: Far less familiar with the EdgeRouter and it's CLI / OS. Missing config or miss-configuration likely exists o...

tramseyG4S · 07-19-2022

I've spent the past couple of days trying to configure and setup the other end of my S2S vpn. That is, I have configuration now on the Ubiquiti EdgeRouter (site 2), but I don't seem to see anything coming up. I more so figure its a problem with the E...

Member Since	‎05-23-2018 10:36 AM
Date Last Visited	‎08-02-2023 12:02 AM
Posts	17
Total Helpful Votes Received	18

User Statistics

User Activity

Banner token line-desc

ASA: configuring RA and site-to-site VPN together

Using PBR to override a (loopback) directly connected network

Re: Using PBR to override a (loopback) directly connected network

Re: Banner token line-desc

Re: Banner token line-desc

Re: ASA: configuring RA and site-to-site VPN together

Re: ASA: configuring RA and site-to-site VPN together