Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello guys,
I have 2 WLCs 5508 on which I would like to enable HA SSO functionality. But, I have a problem. I can't activate the WLC's RP ports. The RP ports are connected through L2 switches. On these switches, the RP ports always remain in the "n...
Hi everyone,
I have an issue. One of my APs is constantly disassociated from the controller even if it is reachable all the time. My company uses a couple of Cisco 5500 WLCs, and the AP is a AIR-CAP2702I-E-K9. Below the AP's time statistics.
No logg...
Hi everyone,
I have an issue. One of my APs is constantly disassociated from the controller even if it is reachable all the time. My company uses a couple of Cisco 5500 WLCs, and the AP is a AIR-CAP2702I-E-K9. Below the AP's time statistics.
No lo...
Hi everyone,I have an issue. One of my APs is constantly disassociated from the controller even if it is reachable all the time. My company uses a couple of Cisco 5500 WLCs, and the AP is a AIR-CAP2702I-E-K9. Below the AP's time statistics. Time Stat...
Hi,I bet this question has been asked many times, but i couldn't find any satisfying answer.Is there a CLI command to force an AP to join another WLC without the need of rebooting it.My enterprise uses two 5508 WLC.Thanks in advance for your answers
I just noticed that , on the genreal AP's config GUI , the CAPWAP Preferred Mode is set to Not-Configured. Which is not the case on the other APs. Can that affect the AP behaviour?
The ip address matches the AP's mac address only. I rebooted the AP , and now it seems to be ok. I'm monitoring it through the terminal via telnet for the moment.
The fact is that im using only POE by now. Im no longer using the power injector. Also, what is strange, is that the AP does not reboot, but only lose the association with the WLC frequently. I issued a ping for like 10 min or more, and what i could ...
Thank you Patoberli for your answer. I checked the cabling and the result was okay. The AP was first powered by a power injector. Then i switched it to be power through POE, but the issue was not resolved. I'll try to use another switch port and see ...
