Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can anyone confirm if GLC-TE is supported on C9500-48YAC switch?
I got this from TMG Matrix and it shows supported but would like to confirm if anyone is using in their environment.
TIA
Hitesh
Hi,
I am trying to figure out destination NAT for all DNS traffic where destination address can be any public IP traversing through the router and it should get natted to specific IP address located on network present out of outside interface
IPtable...
HiWe had working SGBP on Cisco 7200's and when we migrated to ASR's i dont see that feature available on it.We had this functionality to achieve Multichassis MLPPP. Can any one confirm if this can be achieved on ASR's?Cisco IOS XE Software, Version 0...
Hi all,I am trying to setup Half duplex vrf on LNS where spokes and hub are connected to same PE. I have tested this but the traffic from spoke to spoke is routed locally on the LNS.I have attached the configuration, topology and GNS .net file for re...
Hi,I am researching Cisco MWAM with Cisco 7600 for LNS deployment and have few questions in mind, Hope some one had already worked on it or may be someone from Cisco can tell me about it, as there are less resources available for MWAM on Cisco websit...
Hello,
Synchronization is disabled by default AFAIK. You can't advertise route in BGP unless you have in your RIB, that is the golden rule of thumb.
HTH
Hitesh
