Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to get the WSA to work when redirecting HTTP and HTTPS traffic along the lines of the following:object network WSA-HOST host 10.0.210.2object network obj-10.0.1.0 subnet 10.0.1.0 255.255.255.0object service ORIG-HTTP-PORT service...
HI all,I need to be able to redirect some HTTP traffic to an Ironport WSA (for now) on a DMZ interface, the initial config I'm trying to test is along the lines of the following (don't have access to the ASA at the moment to cut-and-paste, sorry):acc...
Thanks - I fell over the NCSI just today, couldn't figure out why a Windows 7 host suddenly started authenticating using DOMAIN\machinename instead of DOMAIN\username, and no end of reboots would change that. Disabling NCSI by changing that registry ...
The policy doesn't require authentication. Now here are two tests I did, seconds apart, from the same client on 10.0.4.140: First one is where I use NAT as shown above:1329757052.027 118 10.0.4.140 NONE_SSL/200 0 TCP_CONNECT 10.0.210.2:443 - NONE/- -...
Thanks Ken, updated the config in my original post to make it clear. Unfortunately WCCP isn't an option here because of where the users are sitting relative to the WSA, so forwarding in some other way like NAT, or explisitely configuring the clients,...
This works fine, at least in a lab scenario, but there are a few things to be aware of here:1) The computer will get network access, through the computer authentication, without a user logged in. This may or may not be OK, depending on what the secur...
[Editing the article heavily since I found the MS KB article below after my first post]I'm struggeling with exactly the same issue, if I select "user or computer" authentication the Windows 7 client will never attempt machine authentication when the ...
